Scale Tests to Estimate Penetration Force and Stress State of the Silica Sand in Windfarm Foundations
Empreu sempre aquest identificador per citar o enllaçar aquest ítem
http://hdl.handle.net/10045/117987
Títol: | Scale Tests to Estimate Penetration Force and Stress State of the Silica Sand in Windfarm Foundations |
---|---|
Autors: | Soriano-Vicedo, Jorge | Garcia-Barba, Javier | Luengo, Jorge | Negro, Vicente |
Grups d'investigació o GITE: | Ingeniería del Terreno y sus Estructuras (InTerEs) |
Centre, Departament o Servei: | Universidad de Alicante. Departamento de Ingeniería Civil |
Paraules clau: | Offshore | Windfarm | Foundation | Scale test | CBR | Silica sand |
Àrees de coneixement: | Ingeniería del Terreno |
Data de publicació: | 17-de setembre-2021 |
Editor: | MDPI |
Citació bibliogràfica: | Vicedo JS, Barba JG, Frades JL, Valdecantos VN. Scale Tests to Estimate Penetration Force and Stress State of the Silica Sand in Windfarm Foundations. Energies. 2021; 14(18):5904. https://doi.org/10.3390/en14185904 |
Resum: | The analysis of the soil behavior when the pile is driving into the seabed in offshore wind platforms is one of the major problems associated with this new form of clean energy generation. At present, there are no scaled studies carried out analyzing the mechanical and deformational behavior of both the material of the pile supporting the engine (large steel hollow piles with a diameter of 8 m and a thickness of 15–20 cm) and the soil where the pile is driven. Usually, these elements are installed on sands with a very small grain size displaced from the limits of dry–wet beach (water limit) toward the offshore limits, which prevents them from returning to their previous location in a natural way. This paper presents results obtained from scale tests in a steel pool to analyze the behavior of the sand where the piles were installed. First, the California Bearing Ratio (CBR) test was carried out to estimate the soil behavior in similar conditions to the steel pool. The scale tests consisted of the penetration of the steel tube into the sand using a hydraulic press. The objective was to compare the results for three tubes with different diameters, three different speeds, and two kinds of ending on the extreme of the tested element. |
URI: | http://hdl.handle.net/10045/117987 |
ISSN: | 1996-1073 |
DOI: | 10.3390/en14185904 |
Idioma: | eng |
Tipus: | info:eu-repo/semantics/article |
Drets: | © 2021 by the authors. Licensee MDPI, Basel, Switzerland. This article is an open access article distributed under the terms and conditions of the Creative Commons Attribution (CC BY) license (http://creativecommons.org/licenses/by/4.0/). |
Revisió científica: | si |
Versió de l'editor: | https://doi.org/10.3390/en14185904 |
Apareix a la col·lecció: | INV - INTERES - Artículos de Revistas |
Arxius per aquest ítem:
Arxiu | Descripció | Tamany | Format | |
---|---|---|---|---|
Soriano-Vicedo_etal_2021_Energies.pdf | 951,76 kB | Adobe PDF | Obrir Vista prèvia | |
Aquest ítem està subjecte a una llicència de Creative Commons Llicència Creative Commons