Gas production during the pyrolysis and gasification of biological and physico-chemical sludges from oil refinery
Por favor, use este identificador para citar o enlazar este ítem:
http://hdl.handle.net/10045/40240
Título: | Gas production during the pyrolysis and gasification of biological and physico-chemical sludges from oil refinery |
---|---|
Autor/es: | Moltó Berenguer, Julia | García Barneto, Agustín | Ariza, José | Conesa, Juan A. |
Grupo/s de investigación o GITE: | Residuos, Pirólisis y Combustión |
Centro, Departamento o Servicio: | Universidad de Alicante. Departamento de Ingeniería Química |
Palabras clave: | Refinery sludge | Pyrolysis | Gasification | Biogas | Syngas |
Área/s de conocimiento: | Ingeniería Química |
Fecha de publicación: | sep-2013 |
Editor: | Elsevier |
Cita bibliográfica: | Journal of Analytical and Applied Pyrolysis. 2013, 103: 167-172. doi:10.1016/j.jaap.2012.09.012 |
Resumen: | Pyrolysis and gasification of two different sludges coming from a Spanish refinery have been performed at different experimental conditions. A physico-chemical (PC) and a biological (BIO) sludge have been studied. Runs at different heating rates (approx. 4 and 10 K/s) and with different contact time between gases and decomposed sludge have been performed. In general, the ratio H2/CO is higher in pyrolytic runs. The highest ratio is obtained in the pyrolysis at low heating rate and parallel flow, using both sludges. The maximum emission of CO, i.e. the worst combustion conditions, is given in the runs where contact time is minimized and at high heating rates. |
Patrocinador/es: | Support for this work was provided by Junta de Andalucía, Spain (project TEP-6688) and the Generalitat Valenciana, Spain, with projects Prometeo/2009/043/FEDER and ACOMP2011/224, and by the Spanish MCT CTQ2008-05520. |
URI: | http://hdl.handle.net/10045/40240 |
ISSN: | 0165-2370 (Print) | 1873-250X (Online) |
DOI: | 10.1016/j.jaap.2012.09.012 |
Idioma: | eng |
Tipo: | info:eu-repo/semantics/article |
Revisión científica: | si |
Versión del editor: | http://dx.doi.org/10.1016/j.jaap.2012.09.012 |
Aparece en las colecciones: | INV - REMAN - Artículos de Revistas INV - I4CE - Artículos de Revistas |
Archivos en este ítem:
Archivo | Descripción | Tamaño | Formato | |
---|---|---|---|---|
2013_Molto_etal_JAAP_final.pdf | Versión final (acceso restringido) | 854,54 kB | Adobe PDF | Abrir Solicitar una copia |
Todos los documentos en RUA están protegidos por derechos de autor. Algunos derechos reservados.