Identification of Rock Slope Discontinuity Sets from Laser Scanner and Photogrammetric Point Clouds: A Comparative Analysis

Please use this identifier to cite or link to this item:
Información del item - Informació de l'item - Item information
Title: Identification of Rock Slope Discontinuity Sets from Laser Scanner and Photogrammetric Point Clouds: A Comparative Analysis
Authors: Riquelme, Adrián | Cano, Miguel | Tomás, Roberto | Abellán Fernández, Antonio
Research Group/s: Ingeniería del Terreno y sus Estructuras (InTerEs)
Center, Department or Service: Universidad de Alicante. Departamento de Ingeniería Civil
Keywords: SfM | LiDAR | Rock mass | Discontinuity | Orientation
Knowledge Area: Ingeniería del Terreno
Issue Date: 2017
Publisher: Elsevier
Citation: Procedia Engineering. 2017, 191: 838-845. doi:10.1016/j.proeng.2017.05.251
Abstract: Discontinuities play a key role in the mechanical, hydraulic and deformational behaviour of rock masses, frequently having a considerable influence on the stability of rock slopes. They can be characterized by several geometric parameters as the orientation, persistence, spacing, etc. Although orientation has been traditionally measured through well-known techniques as a compass, more recent remote sensing techniques such as 3D laser scanning allow deriving both strike and dip direction of discontinuities. The novel SfM (Structure from Motion) technique, which is much less expensive than 3D laser scanning, is becoming mainstream within the research community. This paper examines the generation of 3D point clouds of a rock slope obtained from both, 3D laser scanning and SfM techniques, and their application to the extraction of the orientations of the main discontinuity sets. To this aim, a selected sector from a cretaceous sedimentary rock cut slope placed in Alicante (Spain) is analyzed using both photogrammetric and terrestrial laser scanner (TLS) point clouds. Using ground control points extracted from printed targets scanned by means of TLS provided very accurate coordinates. As a result of this, the obtained adjustment error was minor than 3 mm. The comparison of the resulting point clouds shows a good correlation when the surface is orthogonal to the line of sight. On the contrary, the SfM dataset showed inaccuracies on sub-horizontal and oblique surfaces. Finally, a geometrical analysis was performed by means of DSE software. Three discontinuity sets were extracted from both point clouds. However, one more was extracted from the TLS dataset, but not from the SfM dataset.
ISSN: 1877-7058
DOI: 10.1016/j.proeng.2017.05.251
Language: eng
Type: info:eu-repo/semantics/article
Rights: © 2017 The Authors. Published by Elsevier Ltd. This is an open access article under the CC BY-NC-ND license (
Peer Review: si
Publisher version:
Appears in Collections:INV - INTERES - Artículos de Revistas

Files in This Item:
Files in This Item:
File Description SizeFormat 
Thumbnail2017_Riquelme_etal_ProcediaEng.pdf655,27 kBAdobe PDFOpen Preview

This item is licensed under a Creative Commons License Creative Commons